Cisco Headend System Release 2.7 Installation Guide
Chapter 3 Installing the DTACS Software for the First Time
30
78-4036705-01 Rev D
Install the DTACS Software
This section provides the steps necessary to install the DTACS software for the first
time.
time.
Important: Be sure that you are using the procedures in this section to install the
DTACS software for the first time. If you are upgrading DTACS software at a site
where it is already installed, use the upgrade procedures found later in this book.
DTACS software for the first time. If you are upgrading DTACS software at a site
where it is already installed, use the upgrade procedures found later in this book.
In the series of screens that follow, you will often have to select a configuration
parameter from a list of parameters. Use the arrow keys to navigate through your
choices and make selections by pressing the spacebar. The system usually places an
X beside the selected parameter.
parameter from a list of parameters. Use the arrow keys to navigate through your
choices and make selections by pressing the spacebar. The system usually places an
X beside the selected parameter.
Important: Be certain that there are no network cables installed or connected to the
DTACS at this time.
1 Insert the Maintenance DVD into the DVD drive of the DTACS.
2 At the ok> prompt, type boot cdrom - install and press Enter. The server boots
DTACS at this time.
1 Insert the Maintenance DVD into the DVD drive of the DTACS.
2 At the ok> prompt, type boot cdrom - install and press Enter. The server boots
from the DVD.
Results:
Results:
The DTACS server reboots and the installation script begins.
The Select a Language window appears.