Cisco Headend System Release 2.7 Installation Guide
Build the Database
78-4036705-01 Rev D
65
Build the Database
Complete the following steps to manually run the buildDtacsDb script and build the
DTACS database.
DTACS database.
Note: This procedure is required for an initial install of DTACSDVD1.2.x.x.
1 As root, type buildDtacsDb and press Enter.
2 When the database build completes, type more /dvs/dtacs/convert.out and press
1 As root, type buildDtacsDb and press Enter.
2 When the database build completes, type more /dvs/dtacs/convert.out and press
Enter.
3 Review the file and make sure there are no errors or warnings.
4 Were there errors or warnings?
4 Were there errors or warnings?
If yes, call Cisco Services.
If no, go to step 5.
5 Did the file indicate that there were No differences found?
If yes, go to step 6.
If no, call Cisco Services.
6 Type dbaccess dtacsdb - and press Enter.
7 Were you able to access the DTACS database?
7 Were you able to access the DTACS database?
If yes, go to step 8.
If no, call Cisco Services.
8 At the > prompt within the database, type select * from mc_config where
mc_name="S-A DB Conversion"; and press Enter. The mc_param_date displays
the version of DTACS code you just loaded.
Example:
the version of DTACS code you just loaded.
Example:
mc_param_data from 1.0_0_5_0 to 1.1_0_1_0 Attemp t 1
9 Did the correct version of code display?
If yes, press Ctrl+C and press Enter to exit the database.
If no, call Cisco Services.