Cisco Headend System Release 2.7 Installation Guide
Chapter 12 Obtain DHCT Information with the tellDhct Utility
152
740020 Rev H
Display Return Path Information
Introduction
The information in this section describes how to use the tellDhct utility to display
return path information for DHCTs.
return path information for DHCTs.
Displaying Return Path Information
Follow these instructions to run the tellDhct utility to display information about the
return path capabilities of a single DHCT or a list of DHCTs.
return path capabilities of a single DHCT or a list of DHCTs.
Note: Refer to Display Formatting Details for the tellDhct Utility, earlier in this
chapter, for a detailed description of the fields displayed in the output.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
chapter, for a detailed description of the fields displayed in the output.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
To obtain information about the return path capabilities for a single DHCT,
showing the IP address of the DHCT in the output, go to step 3.
showing the IP address of the DHCT in the output, go to step 3.
To obtain information about the return path capabilities for a single DHCT,
showing the billing ID of the DHCT in the output, go to step 4.
showing the billing ID of the DHCT in the output, go to step 4.
To obtain information about the return path capabilities for a list of DHCTs,
showing the IP address of the DHCTs in the output, go to step 5
showing the IP address of the DHCTs in the output, go to step 5
To obtain information about the return path capabilities for a list of DHCTs,
showing the billing ID of the DHCTs in the output, go to step 6.
showing the billing ID of the DHCTs in the output, go to step 6.
3 Type tellDhct -h [MAC address or SMSN] and then press Enter. The system
displays information about the return path capabilities for the DHCT.
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct -h 00:01:A6:59:A1:94
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct -h 00:01:A6:59:A1:94