Cisco Headend System Release 2.7 Installation Guide
Display Staging Information
740020 Rev H
155
Display Staging Information
Introduction
The information in this section describes how to use the tellDhct utility to display
DHCT staging information.
DHCT staging information.
Displaying Staging Information
Follow these instructions to run the tellDhct utility to display staging information
about a single DHCT or a list of DHCTs.
about a single DHCT or a list of DHCTs.
Note: Included in the staging information is the date that DHCTs were staged. This
information is lost when system operators run the dbOptimizer program. The
system will display the date DHCTs were staged only for those DHCTs that still
have their staging EMMs.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
information is lost when system operators run the dbOptimizer program. The
system will display the date DHCTs were staged only for those DHCTs that still
have their staging EMMs.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
To display staging information for a single DHCT, go to step 3.
To display staging information for a list of DHCTs, go to step 4.
3 Type tellDhct -s [MAC address or SMSN] and then press Enter. The system
displays staging information for the DHCT.
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct -s 00:01:A6:59:A1:94
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct -s 00:01:A6:59:A1:94