Cisco Headend System Release 2.7 Installation Guide
Display CableCARD/Host Configuration
740020 Rev H
159
Display CableCARD/Host Configuration
Introduction
The information in this section describes how to use the tellDhct utility to display
configuration data related to the CableCARD/host relationship. When used with the
-C option, the tellDhct utility displays the following data:
configuration data related to the CableCARD/host relationship. When used with the
-C option, the tellDhct utility displays the following data:
MACaddress - MAC address of the CableCARD
SM_serial_num - serial number of the secure micro chip
Host_id - ID number of the host to which the CableCARD is bound
active_file_date - the date until which data for the CableCARD/host binding
stays in the BFS file
stays in the BFS file
rev - revoked
Note: This field can have two values: a dash or REV. A dash indicates that the
subscriber can view copy-protected content; REV indicates that the subscriber
cannot view copy-protected content.
Note: This field can have two values: a dash or REV. A dash indicates that the
subscriber can view copy-protected content; REV indicates that the subscriber
cannot view copy-protected content.
Displaying CableCARD/Host Configuration
Follow these instructions to run the tellDhct utility to display configuration data
related to the CableCARD/host relationship.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
related to the CableCARD/host relationship.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
To display data for a single CableCARD, go to step 3.
To display data for a list of CableCARDs, go to step 4.