Cisco Headend System Release 2.7 Installation Guide
Chapter 12 Obtain DHCT Information with the tellDhct Utility
148
740020 Rev H
Display Brick Mode Authorization
Introduction
The information in this section describes how to use the tellDhct utility to indicate
which DHCTs are assigned the brick mode package.
which DHCTs are assigned the brick mode package.
Displaying Brick Mode Authorization
Follow these instructions to run the tellDhct utility in order to indicate which
DHCTs are assigned the brick mode package.
DHCTs are assigned the brick mode package.
Notes:
DHCTs that are assigned the brick mode package appear with a "b" in the pkg
column of the output.
column of the output.
Refer to Display Formatting Details for the tellDhct Utility (on page 147) for a
detailed description of the fields displayed in the output.
detailed description of the fields displayed in the output.
1 If necessary, open an xterm window on the DNCS.
2 Choose one of the following options:
2 Choose one of the following options:
To determine whether a single DHCT has the brick mode package, go to step
3.
3.
To identify DHCTs in a list of DHCTs that have the brick mode package, go
to step 4.
to step 4.
3 Type tellDhct -b [MAC address or SMSN] and then press Enter.
Note: Substitute the MAC address or SMSN of the DHCT for [MAC address or
SMSN].
Example: tellDhct -b 00:40:7B:D6:02:3A
SMSN].
Example: tellDhct -b 00:40:7B:D6:02:3A