Cisco Headend System Release 2.7 Installation Guide

Post-Upgrade Procedures for the loadPIMS and BOSS Web Services

4035749 Rev B

141

5 Insert the directives into the file below where the default entries are located.

Example: The following example contains the default entries for the
/etc/apache2/user-conf/SAIdncs.loadPIMS.auth.conf file:

# This section applies to both http and https

# Access originating locally is allowed by default.

Order Allow,Deny

Allow from localhost

Allow from dncs dncs

Allow from dncsws

# Short instructions for creating and setting a user password

# See /httpd.apache.org for a full list of supported options.

Note: Your recorded allow and deny directives from the
/etc/apache2/conf/boss.http file should go between the following two lines:

Allow from dncsws

# Short instructions for creating and setting a user password

6 Save and close the file when you are finished.
7

Open the /etc/apache2/user-conf/SAIdncs.bossreq.auth.conf file in a text
editor.
Example:

vi /etc/apache2/user-conf/SAIdncs.bossreq.auth.conf

8 Insert the directives into the file below where the default entries are located.

Example: The following example contains the default entries for the
/etc/apache2/user-conf/SAIdncs.bossreq.auth.conf file.

# This section applies to both http and https

# Access originating locally is allowed by default.

Order Allow,Deny

Allow from localhost

Allow from dncs dncs

Allow from dncsws

# Satisfy Any allows any one of the Allow from or Require or SSLRequire

Note:

Your recorded allow and deny directives from the

/etc/apache2/conf/loadPIMS.https file should go between the following two
lines:

Allow from dncsws

and

# Satisfy Any allows any one of the Allow from or Require or SSLRequire

9 Save and close the file when you are finished.