Cisco Headend System Release 2.7 Installation Guide
Create the Private and Public Keys (Standalone Application Servers and RNCS Servers Only)
4042225 Rev A
63
Create the Private and Public Keys (Standalone
Application Servers and RNCS Servers Only)
Important: If you upgraded a system with an integrated Application Server and no
RNCS servers, skip this procedure and go to SR 5.0 Post Upgrade Procedures (on
page 67).
After the upgrade you will have to create the private/public keys between any
independent servers on the system (for example, RNCS servers or a standalone
Application Server). This is necessary due to the Enhanced Security enabled in this
system release. The DNCS must also exchange keys with the RNCS servers.
Important: If your are upgrading an existing SR 5.0 system, private and public keys
are backed up and restored as key files. Skip this procedure.
1
RNCS servers, skip this procedure and go to SR 5.0 Post Upgrade Procedures (on
page 67).
After the upgrade you will have to create the private/public keys between any
independent servers on the system (for example, RNCS servers or a standalone
Application Server). This is necessary due to the Enhanced Security enabled in this
system release. The DNCS must also exchange keys with the RNCS servers.
Important: If your are upgrading an existing SR 5.0 system, private and public keys
are backed up and restored as key files. Skip this procedure.
1
From a root xterm window on the DNCS, type the following command and press
Enter. The Enter the host name of the site you are adding message appears.
Enter. The Enter the host name of the site you are adding message appears.
siteCmd -S
2 Type the host name of the Application Server and then press Enter. The Enter
the IP address of the site you are adding message appears.
Important: Be sure you enter the actual host name of the Application Server.
appservatm, as shown in the following example, is only an example.
Example:
Important: Be sure you enter the actual host name of the Application Server.
appservatm, as shown in the following example, is only an example.
Example:
appservatm
3 Type the IP address of the Application Server and then press Enter. The Do you
want to continue? message appears.
Important: Be sure you enter the actual IP address of the Application Server.
10.253.0.10, as shown in the following example, is only an example.
Example:
Important: Be sure you enter the actual IP address of the Application Server.
10.253.0.10, as shown in the following example, is only an example.
Example:
10.253.0.10