Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations Installation Guide
1-10
Introduction
78-715192-01 Rev C
Configuration Overview
Overview
The Prisma II bdr 2:1 Redundant Transmit Processor is shipped from the factory
with operational parameters set to factory defaults. However, you may choose to
configure the operating parameters so that they are best suited for your application.
Configuration and Monitoring Methods
The Prisma II bdr Transmit Processor may be controlled using one of three different
methods.
•
The Prisma II Intelligent Communications Interface Module (ICIM)
If an ICIM is installed in the Prisma II Chassis, it may be used to configure
If an ICIM is installed in the Prisma II Chassis, it may be used to configure
and monitor Prisma II application modules within its domain. For
instructions on operating this module using the ICIM, refer to Chapter 3,
Operation Using the ICIM.
•
The Local Craft Interface (LCI) software
•
The Local Craft Interface (LCI) software running on a locally connected PC
may be used to configure operating parameters of Prisma II modules. For
instructions on operating this module using the LCI software, refer to
Chapter 4, Operation Using the LCI Software.
•
Cisco’s Transmission Network Control System (TNCS) software
If the ICIM is installed, TNCS software may be used to configure and monitor
If the ICIM is installed, TNCS software may be used to configure and monitor
all functions of the Prisma II modules. For instructions on operating this
module using TNCS, see the manual that was shipped with the TNCS
software, TNCS Administrator Software User’s Guide, part number 730201.
Configuration Summary
Using any of the above methods, you can configure the following parameters.
•
Configure the module in master, slave, or independent mode
•
Enable or disable noise suppression
•
Enable or disable redundant mode
•
Enable or disable transmitter sub-module 1 (top)
•
Enable or disable transmitter sub-module 2 (bottom)
•
Set the amount of RF attenuation for channel A
•
Set the amount of RF attenuation for channel B
For detailed information on configuring this module, see Chapter 3, Operation
Using the ICIM, or Chapter 4, Operation Using the LCI Software.