Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations Installation Guide
78-715192-01 Rev C
Operation Using the LCI Software
4-9
Connecting Your Computer to the Chassis
Introduction
Before you start the LCI software, you must first connect your computer to the
chassis that contains the module(s) you want to communicate with.
Important: The LCI software communicates only with those modules located in the
Important: The LCI software communicates only with those modules located in the
chassis your computer is attached to. To check other modules, you must connect
your computer to the chassis they are located in.
Connecting to the Chassis
To connect your PC to the chassis, follow these steps.
1.
Plug one end of a 9-pin serial extension cable into your computer.
2.
Plug the other end of the cable into the LCI port. This port is labeled “Local
Craft Interface”.