Cisco Headend System Release 2.7 Installation Guide
Verify SR i4.2.2
4036631 Rev B
91
Verify SR i4.2.2
Verifying the System Upgrade
Complete these steps to verify a successful upgrade to SR i4.2.2.
1 Examine the dncsLog file in the /var/log directory to see if there are VASP entry
1 Examine the dncsLog file in the /var/log directory to see if there are VASP entry
errors.
If yes, complete these steps to rebuild the VASP entries.
a Open the DNCS Administrative Console, select the System Provisioning
a Open the DNCS Administrative Console, select the System Provisioning
tab, and then click ATM PVC. The ATM PVC Map List window appears.
b Record all of the information from the ATM PVC Map List window on a
piece of paper.
c Delete all of the entries from the ATM PVC Map List window.
d Re-enter each entry from the recorded information.
If no, go to step 2.
2 Type cd /dvs/dncs/Utilities/doctor and press Enter.
3 Type doctor -vn and press Enter. This command runs the Doctor Report
3 Type doctor -vn and press Enter. This command runs the Doctor Report
generates. Review the Doctor Report to ensure that communications exists
between all DBDS elements.
Important: It is normal for Rovi Corporation sites to report errors on
Application Server checks.
between all DBDS elements.
Important: It is normal for Rovi Corporation sites to report errors on
Application Server checks.
4 Type df -k and then press Enter to verify that you are using no more than 85
percent of the partition capacity of each disk.
Important: If any disk partition lists a capacity greater than 85 percent, contact
Cisco Services at 1-866-787-3866 before proceeding.
Important: If any disk partition lists a capacity greater than 85 percent, contact
Cisco Services at 1-866-787-3866 before proceeding.
5 Complete these steps to perform a slow and fast boot on a test DHCT with a
working return path (2-way mode):
a Boot a DHCT.
a Boot a DHCT.
Note: Do not press the power button.
b Access the Power On Self Test and Boot Status Diagnostic Screen on the
DHCT and verify that all parameters, except UNcfg, display Ready.
Note: UNcfg displays Broadcast.
c Wait 5 minutes.
d Press the power button on the DHCT. The power to the DHCT is turned on.
e Access the Power On Self Test and Boot Status Diagnostic Screen on the
d Press the power button on the DHCT. The power to the DHCT is turned on.
e Access the Power On Self Test and Boot Status Diagnostic Screen on the
DHCT and verify that all parameters, including UNcfg, display Ready.