Cisco Headend System Release 2.7 Installation Guide
Chapter 1 SR i4.2.2 DVD Pre-Upgrade Procedures
14
4036631 Rev B
Verify That the Boot Device is Properly Configured
Before upgrading the DNCS, use the following procedure to verify that the boot
device is properly configured.
1 From an xterm window on the DNCS, type eeprom boot-device and then press
device is properly configured.
1 From an xterm window on the DNCS, type eeprom boot-device and then press
Enter.
Example: boot-device=/pci@1e,600000/pci@0/pci@2/scsi@01/d3k@0,0:a disk net
Example: boot-device=/pci@1e,600000/pci@0/pci@2/scsi@01/d3k@0,0:a disk net
2 Do the results from step 1 show that disk:a is listed as a boot device?
Note: The disk:a boot device should be listed first in the output from the
command executed in step 1.
command executed in step 1.
If yes, the boot device is properly configured.
If no, type eeprom boot-device=disk:a and then press Enter to reset the boot
device to the original disk.
device to the original disk.