Cisco Headend System Release 2.7 Installation Guide
Chapter 3 Provision the DNCS for InView 3.6
38
4019969 Rev B
Verify the Number of Sessions After Adding an
Inband Source
Overview
This section describes how you can ensure that the new inband source was
successfully added to your system.
Verifying the Number of Sessions on the QAM
1 Facing the front of the QAM modulator, press the OPTIONS button to cycle
through the QAM menu screens until you see the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
2 Record the number of sessions in the space provided.
Total Session Count: _______
3 Did the session count increase appropriately from the value you recorded in
Verifying the Number of Sessions on the QAM (on page 19)?
If yes, go to Create an InView Package (on page 39).
If no, go to step 4.
4 From the DNCS Administrative Console, click the System Provisioning tab and
then click Source.
5 Select the InView source you created, click File and select Source Definitions.
6 Select the digital source definition, and select Open. The Set Up Digital Source
6 Select the digital source definition, and select Open. The Set Up Digital Source
Definitions window opens.
7 Is the session active?
If yes, call Cisco Services.
If no, click Teardown Session to tear down and rebuild the session.
8 Wait a few moments until the sessions are rebuilt.
9 Facing the front of the QAM modulator, press the OPTIONS button to cycle
9 Facing the front of the QAM modulator, press the OPTIONS button to cycle
through the QAM menu screens until you see the Session Count screen.
10 If the session count did not increment appropriately, call Cisco Services.