Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations Installation Guide

Installing the Enhanced Digital Reverse Modules in the Node

78-741939-01 Rev C

2-6

Removing the Status Monitor Module

Overview

An optional status monitor module is positioned above the fiber management tray,

in the optical section (housing lid) of the node. This module plugs into the optical

interface board. It has a housing tamper switch, and it monitors the DC voltages, the

AC input voltage, optical transmitter and receiver power levels, node temperature,

and the RF levels.

Removing the Status Monitor Module

Follow these instructions to remove the status monitor module.

Disconnect the power cable that is attached to the status monitor module

from the Status Monitor connection on the RF launch amplifier. The

illustration below shows the status monitor module with the cables

attached.