Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations Installation Guide
Installing the Enhanced Digital Reverse Modules in the Node
78-741939-01 Rev C
2-28
Status Monitoring Connection
Installing and Connecting the Status Monitor Module to the Node
Follow these steps to install and connect the status monitor module to the node.
1. Align the status monitor module to the optical interface board.
2. Insert the status monitor module on the optical interface board.
3. Connect the ribbon cable that is attached to the status monitor module to the
2. Insert the status monitor module on the optical interface board.
3. Connect the ribbon cable that is attached to the status monitor module to the
Status Monitor module connection on the optical interface board.