Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide

 

78-4042922-01 Rev B 

11 

 

The TED server must be connected to the DNCS/ISDS to provide secure services 
throughout the network. This section provides instructions for connecting the TED 
server to the DNCS/ISDS. 

 

Complete these steps to connect the TED server to the DNCS/ISDS. 
1  Verify that the DNCS/ISDS is powered on. 
2  Connect a monitor and a keyboard to the TED to monitor the startup process. 
3 

Insert the other end of the cross-over RJ-45 (Ethernet) cable into the Ethernet port 
on the back panel of the DNCS/ISDS. 
Note: The Ethernet port is port 0 located on the system motherboard of the 
DNCS/ISDS. 

4  Press the power button on the front panel to power on the TED server. 
5  Wait 60 seconds for the power LED to turn on. 
6  Is the power LED illuminated on the front panel of the TED server? 



 

If yes, go to step 10.  



 

If no, go to step 7. 

7  Verify that the power cords are inserted tightly into the power receptacle on the 

back panel of the TED server and into a 120 V AC power source. 

8  Press the power button on the front panel to power on the TED server. 
9  Wait 60 seconds before proceeding to the next step. 
10  After the TED boots, a user name and password prompt appears. For the 

username, enter root, and for the password, enter atlanta. Press Enter. 

11  When prompted, enter a new password for the root account, and press Enter. 
12  When prompted, re-enter the new password and press Enter. 
13  At the prompt, type service ted status and press Enter to confirm that the TED 

service successfully started. 
Example: 

14  Is the TED service running? 



 

If yes, go to step 16. 



 

If no, go to step 15.