Cisco Headend System Release 2.7 Installation Guide
Chapter 1 Initial Installation of RNCS Software
6
4022447 Rev B
Step Procedure
Reference
Parameters Required
–
Create BFS MPEG
sources
sources
Creating BFS MPEG
Sources (on page 44)
Sources (on page 44)
Headend associated with the ASI card
MPEG source name
Device name (ASI)
ASI card IP address
ASI card MAC address
–
Create video MPEG
sources
sources
Headend associated with the source
MPEG source name
Device type
MPEG source IP address
MPEG source MAC address
–
Add a BFS QAM
Adding a BFS QAM
(on page 45)
(on page 45)
Headend name where this BFS QAM resides
QAM name
QAM IP address
Modulation type this QAM uses
QAM MAC address
QAM subnet mask
Default gateway IP address (if used)
Allow SI
Input port
Input transport stream
QAM modulation type
QAM output transport stream ID
Channel center frequency (in MHz)
Hubs associated with this BFS QAM