Cisco Headend System Release 2.7 Installation Guide
Chapter 1 Initial Installation of RNCS Software
38
4022447 Rev B
BFS MAC Address—The unique MAC address of the BFS this site will use to
distribute information. Use this BFS MAC Address as the Session ID MAC
Addr when you define the BFS Inband Sources for this site. This BFS MAC
address is also the same as the previous MAC address.
distribute information. Use this BFS MAC Address as the Session ID MAC
Addr when you define the BFS Inband Sources for this site. This BFS MAC
address is also the same as the previous MAC address.
Online—Select this option (so that a checkmark appears in the box) to
activate the site.
activate the site.
6 Click Save. A Confirmation message appears.
7 Click OK.
8 Click Exit.
7 Click OK.
8 Click Exit.
Creating the RNCS BFS Host
Complete the following steps to add the RNCS BFS host.
1 On the DNCS, click the Application Interface Modules tab.
2 Click BFS Admin. The BFS Admin Sites window opens.
3 Select the new RNCS you added earlier.
4 Click File > Select. The Site BFS Administration window opens.
5 Click the Hosts tab.
6 Click File > New. The Set Up BFS Host window opens.
1 On the DNCS, click the Application Interface Modules tab.
2 Click BFS Admin. The BFS Admin Sites window opens.
3 Select the new RNCS you added earlier.
4 Click File > Select. The Site BFS Administration window opens.
5 Click the Hosts tab.
6 Click File > New. The Set Up BFS Host window opens.
7 Enter the following information:
BFS In-Band Mode—Select either ATM or ASI.
Inband Device Name—If you are using ASI, enter /dev/Hmux0.
Host Name—Enter the host name of the RNCS.
QAM BFS Input TSID—Enter the input TSID of the RNCS BFS QAM.