Cisco Headend System Release 2.7 Installation Guide
Chapter 2 Upgrade of RNCS Software
64
4022447 Rev B
23 Type luactivate LIONN_<version number> and press Enter.
Note: <version number> refers to the version of the RNCS DVD.
Result: The system activates the new version of RNCS software and displays the
following message:
Result: The system activates the new version of RNCS software and displays the
following message:
*************************************************************************
The target boot environment has been activated. It will be used when you
reboot.
NOTE: You must use either init or shutdown when you reboot. If you do
not use one of these commands,
reboot.
NOTE: You must use either init or shutdown when you reboot. If you do
not use one of these commands,
the system will not boot using the target BE.
*************************************************************************
In case of a failure while booting to the target BE, the following
process
process
needs to be followed to fallback to the currently working boot
environment:
environment:
1. Enter the PROM monitor (ok prompt).
2. Change the boot device back to the original boot environment by
typing:
typing:
setenv boot-device disk:a
3. Boot to the original boot environment by typing:
boot
boot
*************************************************************************
Activation of boot environment <LIONN_V1.0.0.x> successful.
24 Type lustatus and press Enter. The system displays the status of the
LiveUpgrade boot environment.
Example: You should see results similar to this example:
Example: You should see results similar to this example:
BE_name
Complete
Active ActiveOnReboot
CopyStatus
--------------------------------------------------------------------
2.0.0.8
yes
yes
no
-
LIONN_V1.0.0.x yes
no
yes
-
Note: The example shows that the new RNCS environment will become active
after the next reboot.
after the next reboot.
25 From an xterm window on the DNCS, type siteCmd [hostname of Sun Fire
server] lionnStop and press Enter. A confirmation message about stopping the
lionn appears.
Example: siteCmd lionn1 lionnStop
lionn appears.
Example: siteCmd lionn1 lionnStop
26 Type y and press Enter. The lionn processes stop.
27 Verify that the lionn processes have stopped by typing siteCmd [hostname of
27 Verify that the lionn processes have stopped by typing siteCmd [hostname of
lionn] ps -ef | grep dvs and press Enter.