Cisco Headend System Release 2.7 Installation Guide
Chapter 2 Backup Recommendations
10
OL-27573-01
Prepare for the Backup
Recording the following information will be useful for any backup or restore
operation, and is especially useful when backing up or restoring across the network.
1 Type the following command in an xterm window on the server you are backing
operation, and is especially useful when backing up or restoring across the network.
1 Type the following command in an xterm window on the server you are backing
up and then press Enter.
ifconfig -a
ifconfig -a
Result: Output similar to the following appears.
bash-3.2# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu
8232 index 1
inet 127.0.0.1 netmask ff000000
ixgbe0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index
2
inet 192.168.1.1 netmask ffffff00 broadcast 192.168.1.255
ether 0:10:e0:57:47:8e
ixgbe1: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index
3
inet 10.253.0.1 netmask ffffc000 broadcast 10.253.63.255
ether 0:10:e0:57:47:8f
ixgbe2: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index
4
inet 192.168.100.102 netmask ffffff00 broadcast 192.168.100.255
ether 0:10:e0:57:47:90
ixgbe3: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index
5
inet 10.78.203.178 netmask ff000000 broadcast 10.255.255.255
ether 0:10:e0:57:47:91
2 Note the dncsatm and the network interfaces and record the information.
Example: These interfaces are noted by ixgbe0 and ixgbe1 in the example from
Step 1.
Step 1.
3 Cross-reference your data from Steps 1 and 2 with what is contained in the
/etc/hosts file.
Note: The data should match. If it does not, resolve the mismatch or call Cisco
Services for assistance.
Note: The data should match. If it does not, resolve the mismatch or call Cisco
Services for assistance.