Cisco Headend System Release 2.7 Installation Guide
Chapter 1 Initial Installation of RNCS Software
8
4012763 Rev B
Connecting to the Console of the V240 Server
After configuring the ALOM port of the V240 server, you are ready to connect to the
console. Complete the following steps to connect to the console of the V240 server.
1 Complete the following steps to remotely log on to the ALOM port of the RNCS
1 Complete the following steps to remotely log on to the ALOM port of the RNCS
server.
a Type telnet [IP address of ALOM port] and then press Enter. A prompt for
a Type telnet [IP address of ALOM port] and then press Enter. A prompt for
the user ID appears.
Note: Substitute the IP address of the ALOM port for [IP address of ALOM
port].
Example: telnet 10.201.0.2
Example: telnet 10.201.0.2
b Type the admin user ID and then press Enter. A prompt for the password
appears.
c Type the password for the admin user and then press Enter. The SC >
prompt appears as the system establishes a telnet session between the DNCS
and the ALOM port.
2 Type console -f and then press Enter.
Results:
A message appears that instructs the user on how to return to the ALOM
port.
Control of the V240 is returned to the console, rather than the ALOM port.
3 Go to
Install the RNCS Software (on page 9).