Cisco Headend Digital Broadband Delivery System User Guide
1-42
Configuring SARA to Enhance Your Subscribers’ Experience
4002178 Rev C
Build and Send a Configuration to All Set-Tops in a Single Hub,
Continued
Building and Sending a Configuration to All Set-Tops in a Hub
After you select the options that you want to configure by hub, the next step is to
build the hub-specific configuration and then send the configuration to all set-tops in
a hub.
Complete the following steps to send a configuration to all set-tops in a hub.
Complete the following steps to send a configuration to all set-tops in a hub.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
Result: The DHCT Configure Prompt window opens.
3.
Click Hub.
Result: The DHCT Configure Prompt window displays a list of hubs in your
Result: The DHCT Configure Prompt window displays a list of hubs in your
network.
Note: Under the Configuration column, the window specifies whether the
Note: Under the Configuration column, the window specifies whether the
hub is using a Global or Hub-Specific configuration. If this is your first time
configuring the options for a hub, it will display Global for all hubs.
4.
Single-click the hub that you want to have a unique configuration.
Important: Double-clicking on a hub that is specified for a global
Important: Double-clicking on a hub that is specified for a global
configuration causes a message to appear that warns you that you are about
to change the global configuration for this hub.