Cisco Headend System Release 2.7 User Guide
Chapter 2 Provisioning SDV Services on the DNCS
50
4024447 Rev C
6 Enter the appropriate values in the following fields:
Bandwidth: Enter the bandwidth rate for the SDV service.
Netcrypt: Select the Netcrypt device that will be multicasting the content for
this service group.
this service group.
Netcrypt I/O Port: Select the Netcrypt GbE port that will multicasting the
content (the same port that is receiving the content from the staging
processor or other source).
content (the same port that is receiving the content from the staging
processor or other source).
SDV Session: Click to enable the SDV session.
MPTS: The incoming stream to the Netcrypt is Multi Program Transport
Stream (MPTS).
Important: In an SDV environment, SPTS should be the standard; therefore,
MPTS should never be select.
Stream (MPTS).
Important: In an SDV environment, SPTS should be the standard; therefore,
MPTS should never be select.
Program Field (only appears when MPTS is selected): Enter the program
number from the incoming stream for this session.
number from the incoming stream for this session.
Stream Delivery Type: Select Multicast or Unicast to define how the content
is received by the Netcrypt for both INPUT and OUTPUT, and then go to
step 7.
Important: In an SDV environment, sources are typically set up as: Multicast
INPUT and Multicast OUTPUT.
is received by the Netcrypt for both INPUT and OUTPUT, and then go to
step 7.
Important: In an SDV environment, sources are typically set up as: Multicast
INPUT and Multicast OUTPUT.
7 Select or enter the following values for the appropriate stream delivery type you
selected in step 6:
INPUT
INPUT
Multicast
–
–
Source IP Address: The IP address of the staging processor (for example,
DCM, Mentor, BMR, or Terayon device) interface that is sourcing the
video.
DCM, Mentor, BMR, or Terayon device) interface that is sourcing the
video.
–
Source IP Address 2 (optional): The IP address of an additional staging
processor interface that is sourcing the video. An additional staging
processor provides redundancy, if needed.
processor interface that is sourcing the video. An additional staging
processor provides redundancy, if needed.
–
Source IP Address 3 (optional): The IP address of an additional staging
processor interface that is sourcing the video. An additional staging
processor provides redundancy, if needed.
processor interface that is sourcing the video. An additional staging
processor provides redundancy, if needed.
–
Destination IP Address: The destination IP address of the multicast
stream incoming to the Netcrypt device.
stream incoming to the Netcrypt device.
–
UDP Port: The destination UDP port number for the incoming content.
Unicast
–
–
UDP Port: The destination UDP port number for the incoming content.