Cisco Headend System Release 2.7 User Guide
Set Up a Single or Redundant SDV Multicast Source
4024447 Rev C
53
6 Enter the appropriate values in the following fields:
Bandwidth: Enter the bandwidth rate for the SDV service.
Netcrypt: Select the backup Netcrypt device that will be multicasting the
content for this service group.
content for this service group.
Netcrypt I/O Port: Select the backup Netcrypt GbE port that will multicasting
the content (the same port that is receiving the content from the staging
processor or other source).
the content (the same port that is receiving the content from the staging
processor or other source).
SDV Session: Click to enable the SDV session.
MPTS: The incoming stream to the Netcrypt is Multi Program Transport
Stream (MPTS).
Important: In an SDV environment, SPTS should be the standard; therefore,
MPTS should never be selected.
Stream (MPTS).
Important: In an SDV environment, SPTS should be the standard; therefore,
MPTS should never be selected.
Program Field: (only appears when MPTS is selected): Enter the program
number from the incoming stream for this session.
Note: Because MPTS must be selected to see this field and SPTS is the
standard, you should never see this field.
number from the incoming stream for this session.
Note: Because MPTS must be selected to see this field and SPTS is the
standard, you should never see this field.
Stream Delivery Type: Select Multicast to define how the content is received
by the backup Netcrypt for both INPUT and OUTPUT, and then go to step 7.
Important: In an SDV environment, backup sources are set up as: Multicast
INPUT and Multicast OUTPUT.
by the backup Netcrypt for both INPUT and OUTPUT, and then go to step 7.
Important: In an SDV environment, backup sources are set up as: Multicast
INPUT and Multicast OUTPUT.
7 Select or enter the following values for the appropriate stream delivery type you
selected in step 6:
INPUT
INPUT
Multicast
–
–
Source IP Address: The IP address of the backup staging processor (for
example, DCM, Mentor, BMR, or Terayon device) interface that is
sourcing the video.
example, DCM, Mentor, BMR, or Terayon device) interface that is
sourcing the video.
–
Source IP Address 2 (optional): The IP address of an additional backup
staging processor interface that is sourcing the video. An additional
staging processor provides redundancy, if needed.
staging processor interface that is sourcing the video. An additional
staging processor provides redundancy, if needed.
–
Source IP Address 3 (optional): The IP address of an additional backup
staging processor interface that is sourcing the video. An additional
staging processor provides redundancy, if needed.
staging processor interface that is sourcing the video. An additional
staging processor provides redundancy, if needed.
–
Destination IP Address: The destination IP address of the multicast
stream incoming to the backup Netcrypt device.
stream incoming to the backup Netcrypt device.
–
UDP Port: The destination UDP port number for the incoming content.