Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes

Verify the Current Software Version on the DNCS

4011046 Rev B

Back Up the Current GQAM Configuration File

Introduction

Before installing the new GQAM software, make a backup file of the config file
currently installed on the DNCS by completing the following steps.

CAUTION:

Do not install new software until you have created a backup of the
configuration file currently installed on your system. Having a backup file
will enable you to restore the previous version of GQAM software in the
unlikely event of a failure.

Restore the previous version of software to your system only when
recommended by Cisco Services.

Backing Up the Current GQAM Configuration File
1 Complete the following steps to log on to the xterm window as root user.

a Type su - and press Enter. The password prompt appears.
b Type the root password and press Enter.

2 Type cd /tftpboot and press Enter to access the tftpboot directory.
3 Type pwd and press Enter. The /tftpboot directory name appears and indicates

that you are in the correct directory.

4 Copy the current configuration file to a backup file.

Example: Type cp –p gqam.config gqam.config.old and press Enter.
Result: A copy of the configuration file gqam.config, which contains GQAM
configuration settings, is saved to a configuration file named gqam.config.old.

5 Remain logged in as root user and go to Install GQAM Software onto the DNCS

(on page 20).