Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Install GQAM Software onto the DNCS
78-4012452-01 Rev B
21
Installing GQAM Software onto the DNCS
Follow these instructions to install GQAM software version 1.2 from the directory
Follow these instructions to install GQAM software version 1.2 from the directory
you created at the beginning of this procedure.
1 Type /usr/sbin/install_pkg and then press Enter.
1 Type /usr/sbin/install_pkg and then press Enter.
Results:
The system lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
2 Type y and press Enter to start the installation. When the installation is complete,
the system displays a message stating that the installation was successful and a
prompt for the root user appears.
Note: The installation should take a minute or less.
3 Was the installation successful?
If yes, type exit and press Enter to log out as root user. Then, go to step 4.
If no, contact Cisco Services.
4 Use the UNIX rm -rfi command to remove the following file and directory:
GQAM12.tar (file)
SAIgqam (directory)
Example: Type rm –rfi GQAM12.tar and press Enter.
Result: A confirmation question message appears asking you to confirm the
Result: A confirmation question message appears asking you to confirm the
removal.
5 Type Yes and press Enter when prompted to remove the GQAM12.tar file and
the contents of the SAIgqam directory.
6 Type exit and press Enter to close the xterm window. You are ready to
determine a sequence for downloading GQAM software version 1.2 to the
GQAM modulators in your system.
7 Go to
Establish a Download Sequence (on page 22).