Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Download GQAM Software to the GQAM Modulators
78-4012452-01 Rev B
29
Resetting the GQAM Modulator Through the DNCS GUI
CAUTION:
All active sessions on the GQAM modulator will be interrupted when the
modulator is reset. DHCTs downstream of the modulator will lose their
ability to display services until sessions are reestablished
.
1 If you have not already done so, provision the modulator on the DNCS.
Note: For instructions on provisioning the GQAM modulator, refer to GQAM
Modulator Model D9479 Hardware Installation and Operation Guide.
2 From the DNCS Administrative Console, click the DNCS tab, click the Element
Provisioning tab, and then click QAM. The QAM List window opens.
3 Open an xterm window on the DNCS for use later in this procedure.
4 Based on the order you determined earlier, select the GQAM modulator that you
4 Based on the order you determined earlier, select the GQAM modulator that you
want to reset by highlighting it in the QAM List window.
Important! Although each GQAM modulator that has been provisioned is listed
16 times, select only 1 of the 16 modulators listed.
Example: The following diagram shows an example of a GQAM modulator
Example: The following diagram shows an example of a GQAM modulator
selected in the QAM List window.
5 Click File and then select Reset. The Question window appears with the name of
the selected GQAM modulator inside the quotation marks (‘… ‘).
Example: The following diagram shows an example of the Question window.