Cisco Headend System Release 2.7 Installation Guide

Page of 50
 
Chapter 1    Introducing the Common Download SoftMux Solution 
 
 
 
4017307 Rev C 
Common Download and Object Carousel on 
TSBroadcaster 
Overview 
Currently, the ocdlManager gives the ASI card a Program Map Table Packet 
Identifier (PMT PID) value on which to build the download stream. The ASI card 
then builds the download stream with a PMT PID of the value given and an 
elementary stream with the PMT PID into the Common Download version table 
(CDVT). The host expects that the PID value in the CDVT is the actual value of the 
elementary PID, not the PMT PID. Therefore, the host cannot find the download 
image data. 
In the short term, the workaround involves setting the PMT PID for ocdlManager to 
150 or another available value on the TSBroadcaster. The new setting causes the ASI 
card to build a PMT with PID 150 and an elementary stream with a PID value of 151. 
The ocdlMgr inserts the PID value 150 into the CDVT. The MUX can then be 
configured to remap PIDS 150 and 151 down to 149 and 150. So, the CDVT value 
appears to point to the download image elementary stream. The SoftMux solution 
corrects this issue. 
Notes: 
 
Use CAQAM software version 2.5.1 or later, or MQAM software version 2.6.10 or 
later. (QAM version 2.4.0 will not save the pass-through mode in the NVMRAM. 
If, for any reason, the QAM reboots, pass-through will need to be re-enabled 
through the craft port.) 
 
The ocdlManager issues are resolved in DNCS software version 4.0 SP1 or later 
(including all related software patches). In versions earlier than DNCS 4.0 SP1, 
the ocdlManager process has a dependency for an active session before pumping 
any data out of the ASI card. If the ocdlManager process is restarted, the QAM 
needs to be taken out of pass-through mode in order for an active session to 
come up on the DNCS. 
 
TSBroadcaster with OCAP Object Carousel and Common Download 
In the following drawing, both the OCAP Object Carousel and the Common 
Download Carousel are on the TSBroadcaster. The objective of this scenario is to 
ensure that the Common Download and Object Carousel are unaffected when 
combined and transmitted through a pass-through QAM.