Cisco Headend System Release 2.7 Installation Guide
Restart the System Components
4042389 Rev A
59
Restart the System Components
Introduction
After installing this software, follow these instructions to restart the system
components.
components.
Important: If a patch was provided, be sure you have installed the patch and
completed the instructions that accompanied it. Then go to Check the Installed
Software Version (on page 56) and complete the instructions there before restarting
the system components.
completed the instructions that accompanied it. Then go to Check the Installed
Software Version (on page 56) and complete the instructions there before restarting
the system components.
Restarting Spectrum
Important: Skip this procedure if you are using DBDS Alarm Manager instead of
Spectrum.
1 From the DNCS Administrative Console Status window, click Control in the
Spectrum.
1 From the DNCS Administrative Console Status window, click Control in the
NMS section of the window. The Select Host to run on window opens.
2 Select the appropriate Host Machine, and then click OK. The Spectrum Control
Panel window opens.
3 On the Spectrum Control Panel window, click Start SpectroSERVER. The
Spectrum Network Management System starts.
4 On the Spectrum Control Panel window, click Exit. A confirmation message
appears.
5 Click OK on the confirmation message. The Spectrum Control Panel window
closes.