Cisco Headend Digital Broadband Delivery System Installation Guide
Chapter 2 DNCS Pre-Upgrade Procedures
46
4042389 Rev A
Stop System Components
Introduction
CAUTION:
Do not continue with the procedures in this section unless you are within a
maintenance window. Performing these procedures outside of a maintenance
window may disrupt services.
maintenance window. Performing these procedures outside of a maintenance
window may disrupt services.
Before continuing with the installation process, follow the instructions in this section
to stop system components.
to stop system components.
Stop Third-Party Servers
Some sites use devices that mount drives on the DNCS or the Application Server.
These devices are usually used to register files with the BFS. Be sure to stop these
devices. Also, be sure to stop any third-party applications.
These devices are usually used to register files with the BFS. Be sure to stop these
devices. Also, be sure to stop any third-party applications.
Stopping Spectrum
1 From the DNCS Administrative Console Status window, click Control in the
NMS section of the window. The Select Host to run on window appears.
2 Select the appropriate Host Machine and then click OK. The Spectrum Control
Panel appears.
3 Click Stop SpectroSERVER. A confirmation message appears.
4 Click OK at the confirmation message. The Status message on the Spectrum
4 Click OK at the confirmation message. The Status message on the Spectrum
Control Panel shows Inactive.
5 Click Exit on the Spectrum Control Panel. A confirmation message appears.
6 Click OK at the confirmation message. The Spectrum Control Panel closes.
6 Click OK at the confirmation message. The Spectrum Control Panel closes.