Cisco Headend System Release 2.7 Installation Guide
Chapter 1 SR 2.8.2/3.8.2/4.3.2 Pre-Upgrade Procedures
26
4038415 Rev A
Check and Record Sessions
Checking the BFS Sessions on the BFS QAM or GQAM
Complete the following steps to check and record the number of pre-upgrade BFS
sessions.
1 Follow these instructions to check the number of active sessions on the BFS QAM
sessions.
1 Follow these instructions to check the number of active sessions on the BFS QAM
and/or GQAM.
a Press the Options button on the front panel of the modulator until the
a Press the Options button on the front panel of the modulator until the
Session Count total appears. Record the Session Count here. __________
b Press the Options button again and record the Program Count here.
__________
Note: If all sessions are encrypted, the Session Count and Program Count
should be equal.
should be equal.
2 In an xterm window on the DNCS, type the following command and press Enter:
auditQam -query [BFS QAM IP address] [output port number]
3 Record the output from step 2 here: _______________________________________
4 Type the following command and press Enter.
4 Type the following command and press Enter.
/opt/solHmux64/vpStatus -d /dev/Hmux0 -P 0
5 Record the Active Streams Count here. __________
6 Do the results of steps 1, 2, and 4 all show the same number of sessions?
6 Do the results of steps 1, 2, and 4 all show the same number of sessions?
If yes, continue with the next procedure in this chapter.
If no, contact Cisco Services for help in resolving this issue.