Cisco Headend System Release 3.2 Installation Guide

 

30 

4038415 Rev A 

In this section you will check and terminate, if necessary, the cmd2000 processes. 
Beginning with SR4.3.2.x, the cmd2000 utility became a service. To start and stop the 
cmd2000 utility you must use the svcadm command as root user to disable these 
processes. 
1  Type the following command and press Enter to determine if any cmd2000 

processes are running. 

2  Are any cmd2000 processes running? 

 

If yes, go to step 3. 

 

If no, go to the next procedure in this chapter. 

3  Determine the SAIdncs version by typing the following command and pressing 

Enter. The system displays the SAIdncs version. 

4  Follow these instructions based upon the version of SAIdncs installed on the 

system. 

 

If the SAIdncs version is 4.3.0.x, follow these instructions. 
a  Type the following command and press Enter for each running cmd2000 

process. 

b  Type the following command and press Enter to verify that all cmd2000 

processes have been terminated. 

Note:  Repeat steps a and b for any cmd2000 processes that remain active. 

 

 

If the SAIdncs version is 4.3.2.x, follow these instructions. 
a  Type the following command and press Enter to verify that the cmd2000 

SMF services are running. The system displays a list of cmd2000 services 
that are online. 

b  Type the following command and press Enter to switch to the root user. 

c  When prompted, type the root password and press Enter. 
d  For each online service, type the following commands and press Enter. 

 

