Cisco Headend System Release 2.7 User Guide
Chapter 1 General Tips
12
4022446 Rev B
Monitoring the Number of Available Service
Groups
Groups
Important: This section pertains to sites that are running SR 4.2.1 or later.
You must actively monitor the number of SDV-enabled service groups on your
system. Complete the following steps to monitor the number of SDV-enabled service
groups on your system.
system. Complete the following steps to monitor the number of SDV-enabled service
groups on your system.
Note: For additional details on configuring your system for SDV, refer to
Provisioning the DNCS to Support SDV Services User Guide (part number 4012948).
1 In the DNCS Monitor window on the DNCS Administrative Console, observe
Provisioning the DNCS to Support SDV Services User Guide (part number 4012948).
1 In the DNCS Monitor window on the DNCS Administrative Console, observe
the status of the sgManager process. The light adjacent to this process should be
green.
green.
2 If the sgManager was unsuccessful in adding the MCDiscovery file to a BFS
carousel, the sgManager process light will turn yellow.
3 To verify that the number of SDV-enabled services groups on your system has
exceeded 475, open the sgManager log file and locate an entry that indicates that
the carousel is full.
the carousel is full.
4 Go to Expanding the Number of Available Service Groups (on page 13).