Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
2-18
Upgrading the MQAM Modulator With MQAM Software Version 2.4.10 78-732583-01 Rev B
Determine Existing Broadcast Sessions
Introduction
By using Report Writer, you can generate a report that lists the existing broadcast
sessions in your system along with the channels and sources in your system. This
section describes how to generate, save, and print the Channels, Sources & Sessions
Report, which lists this information.
Note: If your MQAM modulator will carry VOD sessions, you do not need to
Note: If your MQAM modulator will carry VOD sessions, you do not need to
generate the Channels, Sources & Sessions Report. VOD sessions are set up as
needed when a subscriber requests a session.
Description
The Channels, Sources & Sessions Report lists each display channel (channel number)
in the system. It also displays information about the carriage of each channel (how
the channel is transmitted on the DBDS), starting from each source in your system
and ending with each MQAM modulator in your system.
Channels, Sources & Sessions Report Information
The following shows an example of the Channels, Sources & Sessions Report and
highlights information helpful in verifying a successful upgrade.
The
Channel Num
column lists the display
channels in your system. Display channels
are those to which you can tune the DHCT
to receive each service.
The
Session ID
column lists
the sessions that an MQAM
modulator carries.
The
QAM Name
column lists the name of each
QAM modulator, uniquely identifying each QAM
modulator in the system.