Cisco Headend System Release 2.7 Release Notes
4023675 Rev B
13
Implemented and Open CRs
Open CRs
This section provides a list of open CRs that were identified during testing of
DTACS 1.2. CRs are indexed by ID number in ascending order. Resolutions to these
CRs are currently under investigation or in development.
DTACS 1.2. CRs are indexed by ID number in ascending order. Resolutions to these
CRs are currently under investigation or in development.
This list is not intended to be comprehensive. If you have questions about a
particular CR, contact your account representative.
particular CR, contact your account representative.
CR ID
Title and Impact
106331-02
(HPQC18433)
(HPQC18433)
DTACS DTA Management does not always populate the VCT pull-down
Impact: This does not happen every time. When it does, the operator is
unable to edit the VCT parameter on the DTA.
unable to edit the VCT parameter on the DTA.
Workaround: Reverting to the main console window, then reopening the
Edit DTA Entry window will fix the issue in some, but not all instances.
Edit DTA Entry window will fix the issue in some, but not all instances.
107811-01
DTACS BSG WUI contains references to CVT in link shortcut
Impact: The link displayed in the top left corner of the page may be
erroneous.
erroneous.
Workaround: There is no workaround.
107843-01
BSG Source Association and VCT Name association is not displaying orig
config
config
Impact: After saving changes of source associations to a BSG specific VCT,
the UI does not immediately reflect the update.
the UI does not immediately reflect the update.
Workaround: The user must deselect and then reselect the VCT name
before the most recent changes are reflected in the UI.
before the most recent changes are reflected in the UI.
108028-01
dtacsNeMgr cored while creation/deletion of BSG
Impact: While doing BSG creation and deletion, dtacsNeMgr cored once.
Workaround: There is no workaround.
Note: Testers have been unable to reproduce the same results.
108243-01
DTA Provisioning performance is poor
Impact: DTACS 1.0 permits provisioning of up to 63 DTAs per second.
DTACS 1.2 permits provisioning of no more than 21 DTAs per second, i.e.,
provisioning performance has dropped by two thirds.
DTACS 1.2 permits provisioning of no more than 21 DTAs per second, i.e.,
provisioning performance has dropped by two thirds.
108501-01
DTACS User Defined PID Routes show wrong state
Impact: After defining a user PID (not SI or AMM), the operational state is
shown as "ASI Provisioned" and instead of "Active" on the PID Route
Provisioning WUI. This is incorrect behavior.
shown as "ASI Provisioned" and instead of "Active" on the PID Route
Provisioning WUI. This is incorrect behavior.