Cisco Headend System Release 2.7 Release Notes
Chapter 1 Why Choose System Release 4.2?
28
4012157 Rev B
Workaround: Save the configuration for the GQAM modulator on the DNCS
GQAM GUI, and then reboot the GQAM.
GQAM GUI, and then reboot the GQAM.
CR 61108
When a third-party network management system (NMS) is used to receive alarms
from the DNCS, the session IDs and session numbers will not match the actual
values in the NMS.
from the DNCS, the session IDs and session numbers will not match the actual
values in the NMS.
CR 61767
Users cannot add two programs for a single channel when using a PowerKEY
CableCARD module. The split channel function is not working correctly.
CableCARD module. The split channel function is not working correctly.
CR 62388
The DNCS sends an incorrect provisioning message to the GQAM when a user sets
the switching mode to “Auto” while configuring a dual GigE GQAM from the
DNCS. The GQAM interprets the switching mode as “Manual” instead of “Auto.”
This can be confusing to the user.
the switching mode to “Auto” while configuring a dual GigE GQAM from the
DNCS. The GQAM interprets the switching mode as “Manual” instead of “Auto.”
This can be confusing to the user.
CR 62649
Users cannot disable GQAM ports from the DNCS UI. This creates difficulty when
setting up VOD sessions.
setting up VOD sessions.
CR 62980
The DNCS must bypass the Netcrypt for clear VOD sessions.
CR 63068
System operators cannot create MPEG Multicast sessions on GQAM modulators.
CR 63518
The siManager process does not update correctly when upgrading a system from
SR 2.2 to SR 4.2. After the upgrade, there may be conflicting or duplicate frequencies
and hub parameters associated with the same source. After the duplicates are
resolved, the siManager process does not update.
SR 2.2 to SR 4.2. After the upgrade, there may be conflicting or duplicate frequencies
and hub parameters associated with the same source. After the duplicates are
resolved, the siManager process does not update.
Workaround: Stop and restart the siManager process.
CR 63558
When a user enters invalid data into the Client ID and DSG Tunnel Address Fields
on the Client Filter WUI, the WUI provides a message specifying the correct format
for the data. However, you can still save the WUI with invalid Client ID and DSG
Tunnel Addresses.
on the Client Filter WUI, the WUI provides a message specifying the correct format
for the data. However, you can still save the WUI with invalid Client ID and DSG
Tunnel Addresses.
CR 63755
When a QAM modulator reboots, there is limited bandwidth on QAM channels.