Cisco Headend System Release 2.7 Release Notes
Chapter 3 Install the DNCS Software
42
4019303 Rev C
Restart System Components
Introduction
After you reboot the DNCS and the SARA Server, you must complete the
procedures in this section to restart the following system components in the order
listed:
1 Restart Spectrum NMS.
2 Restart DNCS processes.
3 Restart SARA Server processes.
4 Complete required procedures for Aptiv and MDN servers, if necessary
5 Restart cron jobs, if necessary.
6 Restart the billing system and other third-party applications.
7 If using the RCS feature, restart RNCS processes at each remote site.
procedures in this section to restart the following system components in the order
listed:
1 Restart Spectrum NMS.
2 Restart DNCS processes.
3 Restart SARA Server processes.
4 Complete required procedures for Aptiv and MDN servers, if necessary
5 Restart cron jobs, if necessary.
6 Restart the billing system and other third-party applications.
7 If using the RCS feature, restart RNCS processes at each remote site.
Restarting Spectrum
Important: Skip this procedure if you are using DBDS Alarm Manager instead of
Spectrum.
1 From the DNCS Administrative Console Status window, click Control in the
Spectrum.
1 From the DNCS Administrative Console Status window, click Control in the
NMS section of the window. The Select Host to run on window opens.
2 Select the appropriate Host Machine, and then click OK. The Spectrum Control
Panel window opens.
3 On the Spectrum Control Panel window, click Start SpectroSERVER. The
Spectrum Network Management System starts.