Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Chapter 2 Upgrading the Software
14
4011439 Rev B
5 Type more qamdata and press Enter. A result, similar to the following output,
appears.
6 Did more than one config file appear?
If yes, keep the xterm window open and go to step 7.
7 Do you need to continue to run different versions of QAM software on some
QAMs in your network?
If yes, refer to Load Multiple Versions of QAM Code (on page
56H
33).
If no, go to step 8.
8 Update the QAMs to use the same config file by performing the following steps.
a From the DNCS Administrative Console, click the DNCS tab, and then select
one of the following tabs:
–
For SR 2.7/3.7/4.2 and later, click Network Element Provisioning.
–
For SR 2.5/3.5/4.0 and earlier, click Element Provisioning.
b Click QAM. The QAM List window opens.
c Select the QAM, click File, and select Open. The Set Up QAM window opens.
d Click Advanced Parameters and modify the configuration file, as needed.
c Select the QAM, click File, and select Open. The Set Up QAM window opens.
d Click Advanced Parameters and modify the configuration file, as needed.
9 Go to Checking the Software Version Associated with the config File