Cisco Headend System Release 2.7 Technical References
4040797 Rev A
3
Validation Checks
Validation Checks
The issue described in this Field Notice will only affect GQAM output ports using
SMDGs. This check verifies that the SMDGs have been built.
Important: This check can be performed at any time.
Notes:
SMDGs. This check verifies that the SMDGs have been built.
Important: This check can be performed at any time.
Notes:
The session must be a multicast GigE input session.
This does not apply to ASI input or Unicast GigE sessions.
Validation Procedure
Use this procedure to validate the SMDGs configured on your system.
1 Telnet into the GQAM (or use the craft port) and run print_statmux.
1 Telnet into the GQAM (or use the craft port) and run print_statmux.
Note: The port numbers in the GQAM are 0 based and the port numbers on the
DNCS are 1 based.
DNCS are 1 based.
2 Compare the output of print_statmux to the statmux GUI on the DNCS (Set Up
GQAM GUI > Advanced Parameters > Stat Mux Dejitter Groups) and verify
they match. If they do not match, then the issue described in CR 119669 is a likely
cause.
they match. If they do not match, then the issue described in CR 119669 is a likely
cause.
Example: In the following output, Output Port 0 does not have a SMDG enabled
(note there are no GigaEtherType and GigaEtherValue entries) and Output Port 1
has a SMDG enabled.
(note there are no GigaEtherType and GigaEtherValue entries) and Output Port 1
has a SMDG enabled.
D9479 GQAM>print_statmux
Statmux group list
Output Port : 0
Input Port : 0
State : DISABLE
Counter : 0
Statmux group list
Output Port : 0
Input Port : 0
State : DISABLE
Counter : 0