Cisco Model D-PCG1000 PowerKEY CAS Gateway Technical References
2
4020084 Rev B
Recommendation
Recommendation
Cisco recommends that you complete the following procedure to change the auto
negotiate setting. As you begin this procedure, a computer or terminal server is
required to be connected to the craft port of the GQAM.
Important: This procedure assumes that the GQAM is powered on. If you do not see
Important: This procedure assumes that the GQAM is powered on. If you do not see
a command prompt, press the Enter key until the prompt displays on the screen.
GBIC Module
1 At the command prompt, type gigaautoneg and press Enter. This command
provides the current mode of the interface module.
2 Type gigaautoneg <number> and press Enter. This command changes the auto
negotiate setting.
Important: Type either 1 or 0 for the <number> in the command.
3 Type gigaautoneg and press Enter.
4 Is the GQAM now operating in the correct mode, and does the interface module
4 Is the GQAM now operating in the correct mode, and does the interface module
connect to an input device?
If yes, you have completed this procedure.
If no, contact Cisco Services to verify the interface module is approved by
Cisco.
Dual SFP Module
1 At the command prompt, type gigaautoneg_b and press Enter. This command
provides the current mode of the interface module.
2 Type gigaautoneg_b <number> and press Enter. This command changes the
auto negotiate setting.
Important: Type either 1 or 0 for the <number> in the command.
3 Type gigaautoneg_b and press Enter.
4 Is the GQAM now operating in the correct mode, and does the interface module
4 Is the GQAM now operating in the correct mode, and does the interface module
connect to an input device?
If yes, you have completed this procedure.
If no, contact Cisco Services to verify the interface module is approved by
Cisco.