Cisco Headend System Release 2.7 Troubleshooting Guide
Configuring the EAS on the ISDS
4024428 Rev B
45
3 In the EAS Message section, click FIPS Code. The Assign FIPS Codes to 55-1
QPSKs window opens.
4 Click the Cluster/55-1 QPSK arrow and select a bridge from the list.
5 Click the State arrow and select a state from the list.
6 Click the County arrow and select a county from the list.
7 Click the Subdivisions arrow and select a subdivision from the list or select All
5 Click the State arrow and select a state from the list.
6 Click the County arrow and select a county from the list.
7 Click the Subdivisions arrow and select a subdivision from the list or select All
Subdivisions.
8 Click Add.
9 Repeat steps 4 through 8 until you have assigned all the required FIPS codes to
9 Repeat steps 4 through 8 until you have assigned all the required FIPS codes to
this bridge.
10 Click the Force Tune arrow and select a Force Tune Service from the list.
Notes:
The Force Tune Service you enter here overrides the default Force Tune
Service defined in MMM Config on the ISDS for the messages you send
through this bridge.
If you select None in the Force Tune Service field, the system uses the default
Force Tune Service (if defined in MMM Config on the
product_name_common).
11 Click Apply.
Note: The window remains open after you click Apply. You can modify the
current bridge, or select another bridge to assign FIPS codes and/or a Force Tune
Service before you click Save.
12 Click Save. The system saves your settings and the Assign FIPS Codes to
QPSK/CMTS Bridges window closes.