Cisco Headend System Release 2.7 Troubleshooting Guide
Chapter 5 Configure EAS Events, Messages, and Tests
48
4024428 Rev B
Example: If the Default Duration for the RWT of your EAS encoder/decoder is
15 minutes, your Delay Between Repeats value must be
[(15/2 = 7) + 1 = 8 x 60 = 480 seconds].
Note: Make sure that the Delay Between Repeats is always at least 6 seconds.
Note: Make sure that the Delay Between Repeats is always at least 6 seconds.
9 Click Save. The system saves your changes and the Set Up MMM Configuration
window closes.
10 In the MMM Configuration List window, select File > Close. The MMM
Configuration List window closes.
Setting Up Weekly Tests
This section provides procedures for setting up the RWT on the ISDS.
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click EAS Config. The Set Up Emergency Alert System Configuration window
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click EAS Config. The Set Up Emergency Alert System Configuration window
opens.
4 Highlight the row that contains the Required Weekly Test.
5 Click the Configuration Name arrow. A list of possible configuration names
5 Click the Configuration Name arrow. A list of possible configuration names
appears.
6 Select the configuration (Cfg00) you chose in step 3 of
Configuring Weekly Tests
(on page 47). The configuration you chose appears in the Configuration Name
column.
7 Click Save. The system saves the new RWT configuration.
8 Click Cancel. The Set Up Emergency Alert System Configuration window closes.
8 Click Cancel. The Set Up Emergency Alert System Configuration window closes.