Cisco Cisco DOCSIS EuroDOCSIS Transponder for Compact Amplifiers and Nodes Installation Guide
Cisco Euro-DOCSIS/DOCSIS Transponder
Mounting Instructions
Introduction
This document provides instructions for mounting the Cisco Euro-DOCSIS/DOCSIS
Transponder.
Transponder.
For complete information on Safety Instructions, Installation and Operation of the
transponder, see the
transponder, see the
Cisco Euro-DOCSIS/DOCSIS Transponder Installation and
Operation Guide (I&O Guide), part number 4038488.
To Mount the Transponder
Mounting Steps:
1. Insert the transponder in the Transponder Module Slot of the desired device. Make
1. Insert the transponder in the Transponder Module Slot of the desired device. Make
sure to position the transponder in the correct direction before installation, by
matching its PCB edge into the PCB Slot.
(Cisco Compact Dual Amplifier taken as the device for example)
matching its PCB edge into the PCB Slot.
(Cisco Compact Dual Amplifier taken as the device for example)
Important Note: Make sure that the transponder is inserted in the correct slot.
Note: If the transponder is mounted to the device in an operating CMTS system,
certain LEDs will flash to display the startup process, the upstream and
downstream status. See the Checking the LEDs section the I&O Guide for details.
certain LEDs will flash to display the startup process, the upstream and
downstream status. See the Checking the LEDs section the I&O Guide for details.
2. Push down on the transponder until it clicks into the connectors of the device.
Note: For Cisco Compact Segmentable Node A90200 and A90201, the following
mounting bracket is used for fixing the transponder firmly into its slot. See the I&O
Guide for details.
mounting bracket is used for fixing the transponder firmly into its slot. See the I&O
Guide for details.
3. When the transponder is connected to the desired device, and power is applied, the
LED “POWER” starts to blink.
PCB Slot
Transponder Module Slot
Connector
Mounting Edge
Mounting Screw