Cisco Cisco Workload Automation 6.3 Developer's Guide
72
Using the Master Command Line Utility
Understanding the tesm command for the Master CLI
enableJmx/disableJmx
Syntax
tesm enableJmx/tesm disableJmx
Operation
This command either enables or disables JMX on the master without the master running.
Examples
The following command enables JMX on the master.
tesm enableJmx
The following command disables JMX on the master.
tesm disableJmx
ft
Syntax
tesm ft on/off
Operation
Configures fault tolerance to either on or off by updating the Sysval table in the database. If the flag is set to
on, then it
checks to verify if the backup master and fault monitor exists.
Examples
The following command turns fault tolerance on.
tesm ft on
The following command turns fault tolerance off.
tesm ft off
keystoremgr
Syntax
tesm keystoremgr -svc <service> -reload
Operation
This command carries out management tasks on the keystore(s) maintained by CWA. The following options are
supported:
supported:
Examples
-svc <service> specifies service name to target the command to a particular Adapter service. This is the base
name of Adapter service package. For example, for "webservice.pkg", the base name is "webservice".
name of Adapter service package. For example, for "webservice.pkg", the base name is "webservice".
Use the value ALL in place of <service> to broadcast the command to all active adapters. For example,
-svc ALL
-reload instructs the recipient(s) to reload keystore.