Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
USRM Web Interface - Protocol Adaptors
4039132 Rev B
273
SspTcpServer - Configuration Page
This page allows the operator to configure SspTcpServer parameters for client
connections.
connections.
Parameters
The following table explains the SspTcpServer - Configuration page parameters.
Parameter
Description
DisplayMode
This configuration setting is the standard
DisplayMode setting. The state Config causes the
software to open tables for addition of entries.
DisplayMode setting. The state Config causes the
software to open tables for addition of entries.
ConnectionTimeout
This configuration setting configures the connection
timeout. If the connected server does not send a
message within this time, the USRM drops the
connection to the connected server. Setting this
parameter to 0 indicates that there is no timeout.
timeout. If the connected server does not send a
message within this time, the USRM drops the
connection to the connected server. Setting this
parameter to 0 indicates that there is no timeout.
ClientAcceptMode
This configuration setting determines how client
connections are accepted. The state “Any” causes the
USRM software to accept a connection from any
server. The state “Configured” causes the USRM
software to only accept connections from servers with
an IP address entry in the table.
connections are accepted. The state “Any” causes the
USRM software to accept a connection from any
server. The state “Configured” causes the USRM
software to only accept connections from servers with
an IP address entry in the table.