Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
Chapter 4 Operation
332
4039132 Rev B
ServiceGroupTable.Zone.SGID7 1
To Remove Zone Programs
To remove a zone program, simply set the multicast IP address to 0.0.0.0.
If unique source-specific addresses are used for the zone being removed, we
recommend setting all ScrAddrX fields to n/a when removing a program from a
zone. This removes the zone program from the Offered Progs Zones table. You can
perform this step from either the webUI or the zone configuration file.
recommend setting all ScrAddrX fields to n/a when removing a program from a
zone. This removes the zone program from the Offered Progs Zones table. You can
perform this step from either the webUI or the zone configuration file.
If the zone program to be removed was configured using the webUI, remove the
zone program as follows:
1 Access the Offered Progs Zones table.
2 Select the program to be removed.
3 Set the multicast IP address to 0.0.0.0.
4 Set any SrcAddrX addresses to n/a.
5 Click Commit Changes.
zone program as follows:
1 Access the Offered Progs Zones table.
2 Select the program to be removed.
3 Set the multicast IP address to 0.0.0.0.
4 Set any SrcAddrX addresses to n/a.
5 Click Commit Changes.