Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
Service Group Migration
4039132 Rev B
375
Note: If all Service Groups are being removed from the QAM and the QAM is
going to be removed from the USRM, replace steps 4a – 4c with the procedure to
Remove a QAM chassis from the USRM.
going to be removed from the USRM, replace steps 4a – 4c with the procedure to
Remove a QAM chassis from the USRM.
5 Delete the Service Group from ResourceManager as follows:
a Navigate to the ResourceManager.Service Groups Config page.
b Set the AdminState of the Service Group(s) to be deleted to Delete, and then
b Set the AdminState of the Service Group(s) to be deleted to Delete, and then
click Commit Changes.
Note:
–
–
In order for a Service Group to be deleted, no QAM ports can be
associated with it. If QAM ports are still associated with a service group
when AdminState is set to Delete, the Service Group will remain in the
table with an AdminState of OutOfService. Remove the remaining QAM
ports and set AdminState to Delete again to remove the Service Group.
associated with it. If QAM ports are still associated with a service group
when AdminState is set to Delete, the Service Group will remain in the
table with an AdminState of OutOfService. Remove the remaining QAM
ports and set AdminState to Delete again to remove the Service Group.
–
When you remove a Service Group from a USRM, all STBs in that Service
Group will also be deleted from the USRM.
Group will also be deleted from the USRM.
6 If the QAM will be removed completely from this USRM server, then:
a Navigate to the ResourceManager.QAMs.QAM xyz.Chassis page (where
QAM xyz is an individual QAM named "xyz").
b Set the AdminState to Release, and then click Commit Changes. This
releases all sessions on all output ports of the QAM, and sets the AdminState
to OutOfService.
to OutOfService.
c Set AdminState to Delete, and then click Commit Changes. This deletes the
QAM from the USRM database.
d Refresh the tree and verify that the QAM is gone.
Note: Once a QAM is removed from all USRM servers, it is recommended
that the operator update the DNCS Service Group page(s) by removing the
QAM TSIDs from the Selected Ports window and placing them back into the
Available Ports window.
that the operator update the DNCS Service Group page(s) by removing the
QAM TSIDs from the Selected Ports window and placing them back into the
Available Ports window.
7 On the DNCS Service Group Web UI, set the Primary SDV Server to the new
USRM server.
Note: If changes are to be made to the Selected Ports of the service group, they
should be completed before setting the Primary SDV Server to the new USRM.
Note: If changes are to be made to the Selected Ports of the service group, they
should be completed before setting the Primary SDV Server to the new USRM.
8 Add Resources to the USRM and associate output ports to Service Groups.
Note: The USRM supports all Cisco QAMs (GQAM, RFGW, xDQA) as well as
third party QAMs that adhere to the GQI and NGOD specifications. This
procedure uses Cisco QAMs as examples. When substituting a GQI or NGOD
QAM, refer to earlier sections on adding resources to a USRM for details.
third party QAMs that adhere to the GQI and NGOD specifications. This
procedure uses Cisco QAMs as examples. When substituting a GQI or NGOD
QAM, refer to earlier sections on adding resources to a USRM for details.