Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
Chapter 4 Operation
348
78-4021139-01 Rev D
To Configure Zones Using the Web Interface
A USRM Server can support up to 10 separate zone configurations. Before creating
zones, you must first create zone configurations. To configure zones, you assign
names to each zone you want to set up.
Note: The following steps refer to Web UI Pages under the Applications.SdvSm
Note: The following steps refer to Web UI Pages under the Applications.SdvSm
section of the USRM Web UI.
Perform the following steps to configure your zones.
1 Navigate to the Configuration page of the USRM Server web interface.
2 On the Configuration page, set the Display Mode parameter to Config.
3 Select the Program Zones page from the web interface navigation tree. The
Perform the following steps to configure your zones.
1 Navigate to the Configuration page of the USRM Server web interface.
2 On the Configuration page, set the Display Mode parameter to Config.
3 Select the Program Zones page from the web interface navigation tree. The
Program Zones page appears as shown below.
4 Enter the names for your desired zones in the Name fields and click Commit
Changes. Your zone names are configured.
5 On the Configuration page, set the Display Mode parameter back to Normal. The
Program Zones page now only displays the configured zones.