Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
USRM Web Interface - Platform Components
78-4021139-01 Rev D
67
Parameters
The following table explains the ConfigManager - Software Upgrade page
The following table explains the ConfigManager - Software Upgrade page
parameters.
Parameter
Description
DownloadProtocol
Sets the protocol for downloading the new release of the
software. Two protocols are supported, FTP and SSH.
SSH is the default and is used when receiving an
upgrade from DNCS.
Note: Must have service level access to change to FTP in
Note: Must have service level access to change to FTP in
versions prior to 1.6.0.
FTPHost
Specifies the IP address of the FTP server that contains
the software upgrade file.
FTPUserName
Specifies the user name for the account on the FTP server.
FTPUserPassword
Specifies the password that corresponds to the user
account on the FTP server.
InitiateDownload
Initiates the FTP or SSH download of the software
upgrade. The three states for this parameter are:
Inactive - Inhibits the software download.
Download - Causes the software to be downloaded from
Inactive - Inhibits the software download.
Download - Causes the software to be downloaded from
the download server. The server must be reset in a
separate operation for the software to be upgraded using
this mode.
DownloadInstall - Causes the software to be
DownloadInstall - Causes the software to be
downloaded from the FTP server and then automatically
installed.
Note: The Watchdog service (tnoswdog) must be
Note: The Watchdog service (tnoswdog) must be
running in order for the DownloadInstall to work
properly.
DownloadStatus
Shows the state of the download operation. The states are
InProgress, ConnectionFailed, LoginFailed,
FileNotFound, and Idle. The state names are self-
explanatory. After a download is completed, the state
reverts to Idle.
DownloadProgress
Shows the progress of the download in percentage
complete.
ImageDownloadString
Specifies the name of the file to be downloaded from the
FTP server.
ImageExecuteString
Specifies the name of the file to be activated upon the
next activation of the software.
ImageActive
Displays the name of the software file that is active.