Cisco DNCS System Release 2.8.1 3.8.1 4.3.1 User Guide

Use the following fields when you manage RF parameters for a table-based QAM.

TSID

A unique number to identify the transport stream going from this table-based
QAM out to the hubs in your system. 

You can use any number from 0 to 66,365.

Note: TSID ranges are defined from DNCS System Configuration. If you receive a
range error message, you can change values from the following location: DNCS
tab > System Provisioning tab > DNCS System Configuration >
Advanced Parameters tab

Frequency

The frequency (in MHz) of the channel you will use to send data from this
table-based QAM to the hubs in your system.

You can enter a value in 6 MHz increments from 91 to 861.

Modulation Type

The type of modulation this QAM uses.

Bandwidth

The bandwidth (in Mbps) that the system should reserve for the QAM.

Port Number

The carrier output port associated with the frequency you entered.



